Hello,
Please find the information below for the new RC10B6 Builder's Kit 2 (90053). It's the successor to 90033. Please keep confidential until release, likely later this week. You'll find the features and listing information below. You can pre-order NOW by replying to this email. Please let me know if you have any questions.
New features:
· All 3 B6.1 series gearboxes: laydown, layback, and standup gearboxes included for tuning mass balance to different track surfaces
· Hardware included for gearboxes
· 13mm big bore threaded aluminum shocks (four 23mm bodies and four 21mm shafts) with X-rings for low friction assembly
· 13mm shock springs (orange front, red rear) for most dirt oval and on-road type applications
· Updated B6.4 front end assembly (ball stud mount, steering bellcranks, steering rack, and top plate) with gull wing front arms and blue aluminum front axles
· Updated B6.4 -1 scrub caster and steering blocks
· Wide pivot rear aluminum arm mounts for use with B6.2 series 69mm CVA bones
· RC10B7 rear hubs, B7 upper caps, and B6.2/B7 +2 CVA axles
· B74 rear outer hinge pins included with M3 locknuts
· 13mm diameter 2.5mm thick machined shock pistons
· Updated RC10B7 shock rod ends
· 5mm aluminum clamping wheel hexes
legacy features (from B6 builders support kit):
B6 series Ball differential included
Adjustable differential height to allow drive shaft alignment through all ride height and axle height configuration
Factory Team ball bearing set with 24 precision oiled ball bearings
Set of six 48mm turnbuckles, ball cups, and HD metric ball studs
Aluminum rear ball stud mount with three link positions for maximum adjustability and added strength
Lightweight aluminum one-piece top shaft
Octalock spur gears and 19mm octalock LCF pads
Blue aluminum shock bushings
Black steel LP serrated wheel nuts
3mm I.D. molded plastic spacers included for ball stud and shim needs
Fasteners and metric hardware
New RC10B6.3 servo mounting system with direct-to-chassis aluminum chassis mounts and molded brace with transponder mounting location
+1 carbon fiber steering arms
